not easy to damage

Upgraded version of the entry-level model Einscan SE with extended functionality such as better tracking using markers and improved detail

In addition to our internal furnace capacity

the build plate will heat up to 100 degrees in just 2 minutes (Your printer controller will regulate the power to the build plate to get your preset temperature

Thermal distortion at -55 °C

FLUX - 4 x Pre-Filter Replacement - Beam Air UV Resin not easy to damageFLUX 4 x Pre Filter Replacement Beam Air It is recommended that the Pre filter be replaced every 10 30 hours. Supplied in a pack of 4. Also remember to replace the other filters in a timely manner: Pre Filter (10 30 hours) Medium efficiency filter (50 150 hours) H13 HEPA filter (100 200 hours) Charcoal filter (300 600 hours) How to replace the filters: Open the filter top cover and remove the box from inside. Then take out the Pre Filter and pull the